Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSCONTINUOUSLY VARIABLE TRANSAXLE (CVT) (DIAGNOSTICS)DRIVE CYCLEPROCEDUREDRIVE CYCLE F
2016 Subaru Legacy 2.5i
Drive Cycle F
2016 Subaru Legacy 2.5iSECTION Drive Cycle F
| DTC | Item | Condition |
|---|---|---|
| P0705 | TRANSMISSION RANGE SENSOR "A" CIRCUIT (PRNDL INPUT) | - |
Diagnostic procedure:
- Start the engine.
- Depress the brake pedal and move the select lever to each range at an interval of five seconds.NOTE: Move the select lever in the following order: "P" → "R" → "N" → "D".
- Maintain the engine speed to 2, 000 rpm for five seconds or more.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.