SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSCONTINUOUSLY VARIABLE TRANSAXLE (CVT) (DIAGNOSTICS)ACTIVE TESTOPERATION
2016 Subaru Legacy 2.5i

Active Test: Operation

2016 Subaru Legacy 2.5iSECTION Operation
CAUTION:
  • Be sure to perform the active test while the engine is not running.
  • After executing the active test, execute the Clear Memory Mode.
  1. On «Start» display, select «Diagnosis».
  2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».
  3. On «Main Menu» display, select «Each System Check».
  4. On «Select System» display, select «Transmission Control System».
  5. On «Select Function» display, select «Active Test».
    Item SSM display Execution condition
    Activating the actuator ON/OFF F & R Clutch Solenoid When all of the following conditions are met:
    • P range
    • Ignition switch is ON (engine stops)
    • Battery voltage is 10.9 V or more
    Secondary Solenoid
    Primary Down Solenoid
    Primary Up Solenoid
    AWD Solenoid
    Lock-Up Duty Solenoid
    Lock-Up ON/OFF Solenoid
    NOTE: For detailed operation procedures, refer to "Application help".
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.