Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISSUSPENSIONREAR SUSPENSIONREAR LATERAL LINKREMOVAL
2016 Subaru Legacy 2.5i
Rear Lateral Link: Removal
2016 Subaru Legacy 2.5iSECTION Removal
- Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
- Lift up the vehicle, and then remove the rear wheels.
- Remove the sensor assembly - headlight beam leveler. (Model with auto headlight beam leveler) < Ref. to REMOVAL , Rear Height Sensor. >
- Remove the lateral link assembly - rear.
- Remove the nut and disconnect the rear stabilizer link assembly.
- Remove the bolts and nuts, and remove the lower side of rear shock absorber assembly.
- Remove the bolts and nuts, and remove the lateral link assembly - rear.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.