Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSAIR BAG SYSTEM (SERVICE INFORMATION)
2016 Subaru Legacy 2.5i
Air Bag System (Service Information)
2016 Subaru Legacy 2.5iSECTION Air Bag System (Service Information)
- General Description
- Airbag Connector
- Procedure
- Power Supply
- Airbag Control Module
- Driver's Airbag Module (Roll Connector)
- Passenger's Airbag Module
- Driver's Airbag Module, Curtain Airbag Module And PRETENSIONER
- Front Sub Sensor
- Front Door Impact Sensor
- Side Airbag Sensor And Curtain Airbag Sensor
- Front Door Impact Sensor (Between Airbag Rear Harness And Front Door Harness)
- Side Airbag Module
- Seat Cushion Airbag Module And Buckle Switch RH
- Belt Tension Sensor
- Occupant Detection System (Between Airbag Rear Harness And Seat Harness)
- Procedure
- Inspection Locations after a Collision
- Inspection
- Notes
- Driver's Airbag Module Assembly
- Passenger's Airbag Module
- Seat Cushion Airbag Module
- Side Airbag Module
- Curtain Airbag Module
- Airbag Control Module
- Front Sub Sensor
- Front Door Impact Sensor, Side Airbag Sensor And Curtain Airbag Sensor
- Roll Connector
- Column Assembly - Steering & Steering Wheel
- Passenger's Seat
- Inspection Of Other Parts
- Inspection
- Driver's Airbag Module
- Passenger's Airbag Module
- Seat Cushion Airbag Module
- Side Airbag Module
- Curtain Airbag Module
- Airbag Control Module
- Front Sub Sensor
- Front Door Impact Sensor
- Side Airbag Sensor
- Curtain Airbag Sensor
- Roll Connector
- Airbag Module Disposal (Deployment Processing on Vehicle)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.