Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Mounting System: Removal
2016 Subaru Legacy 2.5iSECTION Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
- Lift up the vehicle.
- Remove the front exhaust pipe. < Ref. to REMOVAL , Front Exhaust Pipe. >
- Remove the center exhaust cover.
- Set the transmission jack under the transmission. Make sure that the support plate of transmission jack does not touch the oil pan.
- Remove the transmission rear crossmember.
- Remove the rear cushion rubber.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.