Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Mounting Bracket
2016 Subaru Legacy 2.5iSECTION Front Mounting Bracket
WARNING: This page is about a different variant/trim than selected.
- Install the bracket to the cradle.
Tightening torque:
65 N.m (6.6 kgf-m, 47.9 ft-lb)
- Install the front mounting bracket to the cradle and the bracket.
Tightening torque:
60 N.m (6.1 kgf-m, 44.3 ft-lb)
- Install the front cushion rubber. < Ref. to FRONT CUSHION RUBBER , INSTALLATION, Engine Mounting. >
- Install the radiator fan and fan motor assembly. < Ref. to INSTALLATION , Radiator Fan and Fan Motor Assembly. >
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.