Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Outline Of Diagnosis
- When cold, the abnormality in the control of target engine speed increase is detected. (P050A)
- Idle speed diagnosis
Judge as NG when actual engine speed is not close to target engine speed at cold start.
- Detect malfunctions of the catalyst advanced idling retard angle control. (P050B)
Judge as NG when ECM is not controlling the angle properly during catalyst advanced idling retard angle control.
- Final ignition timing diagnosis
Judge as NG when actual retard amount is under the specified value at cold start.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.