Execution Condition

2016 Subaru Legacy 2.5iSECTION Execution Condition
WARNING: This page is about a different variant/trim than selected.
Secondary Parameters Execution condition
Battery voltage ≥ 10.9 V
Barometric pressure ≥ 75.1 kPa (563 mmHg, 22.2 inHg)
Activation of soaking timer Completed
Engine coolant temperature ≥ 4.4 °C (39.9 °F)
  and
  < 45 °C (113 °F)
Accumulated purge amount during previous driving cycle ≥ Value of Map 1 (g)
ENGINE COOLANT TEMPERATURE SPECIFICATION 1

Engine coolant temperature °C (°F) 0 (32) 30 (86) 35 (95) 40 (104) 45 (113)
Accumulated purge amount during previous driving cycle g (oz) 128 (4.51) 28 (4.51) 480 (16.93) 832 (29.34) 1184 (41.76)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.