Malfunction Indicator Light Does Not Go Off: Trouble Symptom

2016 Subaru Legacy 2.5iSECTION Trouble Symptom
WARNING: This page is about a different variant/trim than selected.

Although malfunction indicator light comes on when the engine runs, DTC is not shown on the Subaru Select Monitor or general scan tool display.

DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK DTC.Β  Is DTC of engine or LAN system displayed? < Ref. to OPERATIONΒ , Read Diagnostic Trouble Code (DTC). > Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". < Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC)Β . > < Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > Go to step 2Β  .
2 CHECK COMBINATION METER.Β 
Perform the self-diagnosis for combination meter system. < Ref. to SELF-DIAGNOSIS DISPLAY MODE , OPERATION, Combination Meter System. >
Does the malfunction indicator light illuminate and go off normally? Replace the ECM. < Ref. to ENGINE CONTROL MODULE (ECM) . > Replace the meter case assembly of combination meter. < Ref. to COMBINATION METER . >
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.