Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Execution Condition
2016 Subaru Legacy 2.5iSECTION Execution Condition
| Secondary Parameters | Execution condition |
|---|---|
| < Timer diagnosis > | |
| Battery voltage | ≥ 10.9 V |
| Ignition switch | OFF |
| Elapsed time after starting the engine | > 600 s |
| and | |
| < 61380 s | |
| < Full count diagnosis > | |
| Battery voltage | ≥ 10.9 V |
| Ignition switch | OFF |
| Counter in ECM | ≥ 4 s |
| < Soaking timer IC setting diagnosis > | |
| Battery voltage | ≥ 10.9 V |
| Ignition switch | OFF |
| < Timer diagnosis (during soaking) > | |
| Battery voltage | ≥ 10.9 V |
| Ignition switch | OFF |
| < Wake-up diagnosis > | |
| Ignition switch | ON |
| Time in the soaking timer IC | > 3600 s |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.