Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISENGINE MECHANICALCOOLING SYSTEM (MECHANICAL)ENGINE COOLING SYSTEM (H4DO)ACTIVE GRILLE SHUTTERINSTALLATION
2016 Subaru Legacy 2.5i
Active Grille Shutter: Installation
2016 Subaru Legacy 2.5iSECTION Installation
- Install the ambient sensor.
- Install the active grille shutter using the bolts securing the active grille shutter.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Connect the connector to the active grille shutter actuator.
- Connect the connector to the ambient sensor.
- Install the front bumper. < Ref. to INSTALLATION , Front Bumper. >
- Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
- When the active grille shutter has been replaced, perform the calibration (execute the system operation check for ACTGS control). < Ref. to OPERATION , Active Test. >
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.