SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENTATION SYSTEM & DRIVER INFORMATION CENTERCOMBINATION METERREMOVAL
2016 Subaru Legacy 2.5i

Combination Meter: Removal

2016 Subaru Legacy 2.5iSECTION Removal
CAUTION: When the combination meter is replaced, perform the variant work. < Ref. to VARIANT WORK , OPERATION, Combination Meter System. >
  1. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  2. Release the lock, tilt the steering column to the lowest end and fully extend the column by the telescopic system.
  3. Remove the cover assembly - instrument panel LWR driver. < Ref. to REMOVAL , Instrument Panel Lower Cover. >
  4. Remove the visor assembly - lower.
    1. Release the clips and claws.
    2. Disconnect the connector and remove the visor assembly - lower.
      CAUTION:
      • Being careful not to damage the visor assembly - lower, slowly remove the clips and claws one by one from the right and left edges of visor assembly - lower.
      • When using a clip remover, wrap it with protective tape or cloth.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.