Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENTATION SYSTEM & DRIVER INFORMATION CENTERCOMBINATION METERINSTALLATION
2016 Subaru Legacy 2.5i
Combination Meter: Installation
2016 Subaru Legacy 2.5iSECTION Installation
CAUTION:
- Make sure the electrical connector is connected securely.
- Make sure that each meter operates normally.
- When the combination meter assembly of the model without keyless access with push button start has been replaced, perform the registration of immobilizer. (Except for C0 and C5 models) For the relevant procedures, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".
- When the combination meter is replaced, perform the variant work. < Ref. to VARIANT WORK , OPERATION, Combination Meter System. >
- Install the combination meter assembly.
Tightening torque:
7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Install the visor assembly - lower.
- Install the cover assembly - instrument panel LWR driver.
- Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.