SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENTATION SYSTEM & DRIVER INFORMATION CENTERCOMBINATION METER SYSTEMOPERATIONVARIANT WORKOPERATION PROCEDURE A
2016 Subaru Legacy 2.5i

Operation procedure A

2016 Subaru Legacy 2.5iSECTION Operation procedure A
  1. Connect the Subaru Select Monitor.
  2. On «Start» display, select «Diagnosis».
  3. On «Vehicle selection» display, enter vehicle information and select «Confirmed».
  4. On «Main Menu» display, select «Each System».
  5. On «Select System» display, select «Combination Meter» and then select «Enter».
  6. On «Select Function» display, select «Work Support».
  7. From the work support list, select «Read Control module setting information».
  8. Save and close the file.
  9. Replace the combination meter assembly with a new part.
  10. On «Main Menu» display, select «Each System».
  11. On «Select System» display, select «Combination Meter» and then select «Enter».
  12. On «Select Function» display, select «Work Support».
  13. Select «Write ECU setting save data», and open the file stored in «Read Control module setting information ».
  14. When the confirmation screen indicating the vehicle information appears, check that the correct information is displayed and click the «OK» button.
  15. Confirm that «Write operation was completed.» is displayed, and click the «OK» button.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.