Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
TFT display check
2016 Subaru Legacy 2.5iSECTION TFT display check
Check the TFT display.
NOTE:
- The meter needle indicate 0 or the lowest position.
- ILL indication illuminates at the same brightness as immediately before entering "TFT display check".
- After No. 6 is displayed in the illumination order, display is repeated from No. 1 again.
- The version display contents of the illumination order No. 1 varies depending on the vehicle.
- Press the trip reset switch.
- After a buzzer sounds for 0.5 seconds and "STEP3" is displayed on TFT, the TFT display check mode is initiated.
Order TFT display Warning/indicator light Time (sec) 1 Version display & black Light OFF 10 2 Red Light OFF 10 3 Green Light OFF 10 4 Blue Light OFF 10 5 White Light OFF 10 6 Color gradation Light OFF 10
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.