Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Self-Diagnosis Display Mode: Notes
The combination meter self-diagnosis can be performed as a single unit according to the following procedure.
When the self-diagnosis display mode operates, it switches in the order of [1. Meter pointer operation check]
→ [2. Meter pointer indication check] → [3. TFT display check].
- ProcedureCAUTION: Perform the steps described in (1) through (4) within 10 seconds.
(1) Within 3 seconds after turning the ignition switch to ON, set the parking light switch or the headlight switch to ON. (2) While the switch is in ON, press the trip reset switch three times. (3) Turn the parking light switch or the headlight switch to OFF, and press the trip reset switch three times. (4) Turn the parking light switch or the headlight switch to ON, and press the trip reset switch three times. - Go to the self-diagnosis display mode.CAUTION: If the procedure is not performed properly, turn the ignition switch from ON to OFF to stop the operation halfway, and then proceed from step (1) to (4).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.