SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVEHICLE DYNAMICS CONTROL (VDC) SYSTEM (SERVICE INFORMATION)VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)MAINTENANCE MODEVDCCM PARAMETER SELECTION
2016 Subaru Legacy 2.5i

VDCCM Parameter Selection

2016 Subaru Legacy 2.5iSECTION VDCCM Parameter Selection
NOTE:
  • When the VDCCM & H/U is replaced with a replacement part, be sure to perform the parameter selection/registration to the VDCCM & H/U using this function.
  • To check the applied model, refer to the "Model number plate" attached to the vehicle. < Ref. to IDENTIFICATION , Identification. >
  • If you entered a wrong applied model, you can re-write it.
  • When the registration has not been performed, the DTC code "Parameter" is detected together with the ABS/EBD/VDC warning light illumination.
  • This function can be used for the replacement part of VDCCM & H/U.
  1. Perform selection of parameter.
    1. Connect the Subaru Select Monitor to data link connector.
      NOTE: For detailed operation procedures, refer to "Application help".
    2. Turn the ignition switch to ON.
    3. On «Start» display, select «Diagnosis».
    4. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
    5. On «Main Menu» display, select «Each System».
    6. On «Select System» display, select «Brake Control System» and select «Enter».
    7. On «Select Function» display, select «Work Support».
    8. On «Work Support» display, select «Selection of Parameter».
  2. Check the applied model and option code indicated on the "Model number plate". < Ref. to IDENTIFICATION , Identification. >
  3. Enter the applied model of 7-digit alphanumeric characters and press the [Enter] key.
  4. When the option code input screen appears after entering the applied model, enter the option code consisting of 4-digit alphanumeric characters, and press the «Enter» key. When the option code is 3 digits, add "0" (zero) in front and enter the code as 4 digits.
  5. When the confirmation screen indicating the vehicle information appears, check that the correct applied model and grade are displayed and click the «OK» button.
    NOTE: When the displayed applied model and grade are different from those of the vehicle, perform registration operations again after clicking the [OK] button.
  6. Execute the Clear Memory Mode after parameter selection and registration operations because the DTC for "Parameter selection error" is memorized. < Ref. to CLEAR MEMORY MODE . >
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.