SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVEHICLE DYNAMICS CONTROL (VDC) SYSTEM (SERVICE INFORMATION)VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)MAINTENANCE MODEVDCCM PARAMETER READING
2016 Subaru Legacy 2.5i

VDCCM Parameter Reading

2016 Subaru Legacy 2.5iSECTION VDCCM Parameter Reading
  1. Perform reading of parameter.
    1. Connect the Subaru Select Monitor to data link connector.
      NOTE: For detailed operation procedures, refer to "Application help".
    2. Turn the ignition switch to ON.
    3. On «Start» display, select «Diagnosis».
    4. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
    5. On «Main Menu» display, select «Each System».
    6. On «Select System» display, select «Brake Control System» and select «Enter».
    7. On «Select Function» display, select «Work Support».
    8. On «Work Support» display, select «Reading of parameter: ECM to SSM».
  2. Save and close the file.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.