Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Mode 2
2016 Subaru Legacy 2.5iSECTION Inspection Mode 2
| DTC | Item | Note |
|---|---|---|
| B2779 | REMOTE CONTROL ENGINE STARTER COLLATION | - |
Diagnostic procedure:
- Prepare for the inspection mode. < Ref. to PREPARATION FOR THE INSPECTION MODE , PROCEDURE, Inspection Mode. >
- Register the remote engine starter, and operate it.
- Read the DTC and check that the DTC is not displayed. < Ref. to
READ DIAGNOSTIC TROUBLE CODE (DTC) . >NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.