Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEM - SECURITY AND LOCKSREMOTE OPENERSREMOVALFUEL FLAP
2016 Subaru Legacy 2.5i
Fuel Flap
2016 Subaru Legacy 2.5iSECTION Fuel Flap
- Open the fuel flap and remove the fuel filler cap.
- Turn the fuel filler pipe protector in the direction of the arrow to unlock and remove it.
- Remove the trim panel - rear apron RH. (OUTBACK model) < Ref. to OUTBACK MODEL , REMOVAL, Rear Quarter Trim. >
- Remove the trim panel - trunk side RH. (Sedan model) < Ref. to REMOVAL , Trunk Room Trim. >
- Remove the cable assembly - fuel inside the quarter panel.
- Turn the cable assembly - fuel counterclockwise and pull toward vehicle rear.
- Disconnect the ring clips.CAUTION: Always replace with a new part, because engagement of the claw weakens.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.