Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Stopping Keyless Access System Function By Using Access Key
2016 Subaru Legacy 2.5iSECTION Stopping Keyless Access System Function By Using Access Key
- Open the driver's door, and then push the door lock knob forward (LOCK direction).
- Press the lock button of access key and trunk/rear gate button simultaneously for five seconds or more.
- The buzzer sounds for two seconds, and the function stops.NOTE: Perform the same procedures to re-activate the keyless access system from the disabled condition.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.