Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTENTERTAINMENT SYSTEMREARVIEW CAMERA SYSTEMINSTALLATIONOUTBACK MODEL
2016 Subaru Legacy 2.5i
Outback Model
2016 Subaru Legacy 2.5iSECTION Outback Model
- Install the rearview camera assembly.
- Install the garnish assembly - rear gate.
Tightening torque:
4.5 N.m (0.5 kgf-m, 3.3 ft-lb)
- Install the trim panel - rear gate.
- Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
- Confirm the marker position. < Ref. to INSPECTION , Rearview Camera System. >
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.