Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTENTERTAINMENT SYSTEMPOWER AMPLIFIERREMOVAL

2016 Subaru Legacy 2.5i

Power Amplifier: Removal

2016 Subaru Legacy 2.5iSECTION Removal

NOTE: Remove the power amplifier assembly after sliding the passenger's seat back and forth as necessary.

Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
Remove the power amplifier - assembly.
1. Remove the harness clip, and disconnect each connector.
2. Remove the nut and remove the power amplifier - assembly.
  
  Fig 1: Locating Power Amplifier Assembly Harness Clip, Connector And Nut
  Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.