SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTENTERTAINMENT SYSTEMEXTERNAL CONNECTION TERMINALREMOVAL
2016 Subaru Legacy 2.5i

External Connection Terminal: Removal

2016 Subaru Legacy 2.5iSECTION Removal
  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. < Ref. to BATTERY , NOTE, Repair Contents. >
  2. Remove the heater control assembly. < Ref. to REMOVAL , Control Panel. >
  3. Remove the cover assembly - front and the console box assembly. < Ref. to REMOVAL , Console Box. >
  4. Release the claws, and then remove the panel center LWR.
    Fig 1: Identifying Panel Center LWR Claws
    G10309172Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the screws and remove the pocket assembly - CTR.
    Fig 2: Locating CTR Pocket Assembly Screws
    G10309173Courtesy of SUBARU OF AMERICA, INC.
  6. While pressing the claw, press it in form the rear to remove the unit assembly - AUX.
    Fig 3: Removing AUX Unit Assembly
    G10272684Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.