SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEM (SERVICE INFORMATION)SPOT MAP LIGHTREMOVAL
2016 Subaru Legacy 2.5i

Spot Map Light: Removal

2016 Subaru Legacy 2.5iSECTION Removal
NOTE:
  • The spot map light is a single unit with the overhead console or stereo camera cover. Replace the overhead console or stereo camera cover if faulty.
  • Do not remove the spot map light if removing the bulb only.
  1. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  2. Remove the overhead console. (Models without EyeSight)
    1. Release the clips and claws.
    2. Disconnect the connector, and remove the overhead console.
      Fig 1: Identifying Overhead Console Clips And Claws
      G10277256Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the stereo camera cover assembly. (Models with EyeSight) < Ref. to REMOVAL , Stereo Camera. >
  4. Release the claws, then detach the spot map light cover and bulb.
    CAUTION:
    • Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.
    • When using a flat tip screwdriver, apply protective tape or cloth and be careful not to cause damage.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.