Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEM (SERVICE INFORMATION)HAZARD SWITCHINSPECTION
2016 Subaru Legacy 2.5i
Hazard Switch: Inspection
2016 Subaru Legacy 2.5iSECTION Inspection
- Measure the resistance between connector terminals.
Preparation tool:Β
Circuit testerΒ
Terminal No. Inspection conditions Standard 2 - 3 Switch OFF 1 MΞ© or more Switch ON Less than 1 Ξ© - Apply battery voltage between the connector terminals to check the lighting condition of the light.
Terminal No. Inspection conditions Specification 4 (+) - 1 (-) Apply battery voltage. Light ON - Replace the switch - hazard if the inspection result is not within the standard value.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.