SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2016LEGACY 2.5IREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESLAN COMMUNICATION SYSTEM (DIAGNOSTICS)DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)DTC U0422 INVALID DATA RECEIVED FROM BODY CONTROL MODULETROUBLE SYMPTOM
2016 Subaru Legacy 2.5i

DTC U0422 Invalid Data Received From Body Control Module: Trouble Symptom

2016 Subaru Legacy 2.5iSECTION Trouble Symptom

Cooperation control with body integrated unit does not operate properly.

DIAGNOSTICS PROCEDURE

Step Check Yes No
1 CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.  Was the basic diagnostic procedure performed up to STEP 8? Go to step 2  . Perform the basic diagnostic procedure. < Ref. to BASIC DIAGNOSTIC PROCEDURE . >
2 CHECK DTC. 
Check the displayed DTC.		 Are DTCs other than U*** displayed? Perform the diagnosis according to DTC. Go to step 3  .
3 CHECK DTC. 
Check the displayed DTC.		 Is DTC for the bus off or the data no-receive displayed? Perform the diagnosis according to DTC. Go to step 4  .
4 CHECK DTC. 
Check the displayed DTC.		 Is U0422 a current malfunction? Go to step 5  . Go to step 9  .
5 CHECK DTC. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the body integrated unit connector.
  3. Connect the disconnected connectors.
  4. Read the DTC using Subaru Select Monitor.
 Is U0422 a current malfunction? Go to step 6  . Go to step 9  .
6 CHECK DTC. 
Using the Subaru Select Monitor, read DTC of all the systems.		 Is the body integrated data abnormal detected in several modules? Replace the body integrated unit. < Ref. to BODY INTEGRATED UNIT . > Go to step 7  .
7 REPLACE MODULE. 
  1. Replace the body integrated unit.
  2. Read the DTC using Subaru Select Monitor.
 Is U0422 a current malfunction? Go to step 8  . System is normal.
8 CHECK MODULE. 
  1. Reinstall the body integrated unit.
  2. Replace the module that the DTC has been detected.
  3. Read the DTC using Subaru Select Monitor.
 Is U0422 a current malfunction? Replace the body integrated unit. < Ref. to BODY INTEGRATED UNIT . > System is normal.
9 CHECK HARNESS. 
  1. Shake the harness, and check for poor contact.
  2. Using the Subaru Select Monitor, read DTC of CAN system.
 Is U0422 a current malfunction? Repair the poor contact of harness, or replace the harness. Go to step 10  .
10 CHECK CONNECTOR. 
Check the connector used for high speed CAN for poor contact.		 Is there poor contact of connector? Repair the connector that has poor contact, or replace harness. It is possible that temporary poor communication occurs. Delete the DTC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.