Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Confirm Current Setting
2016 Subaru Legacy 2.5iSECTION Confirm Current Setting
- On «Start» display, select «Diagnosis».
- On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
- On «Main Menu» display, select «Each System».
- On «Select System» display, select «Body Control» and then select «Enter».
- On «Select Function» display, select «Customize».
- Save the setting.
Required items for new registration. (Except for system not equipped)
Item Content Note number of regist. 1 2 3 4 Number of registered key Off delay time OFF 10 Sec 20 Sec 30 Sec - Auto Light Sensitivity Adjustment Dull Normal (Standard) Sensitive Very sensitive - Power rear gate setting ON OFF - Lane change signal setting ON OFF - Rear wiper auto setting ON OFF - TPMS Setting ON OFF - Driver's Door Unlock Setting ALL Selection - Rear Gate Unlock Setting ALL Selection - Wiper link Auto Light Setup ON OFF - High Beam Assist Function ON OFF - Head Lamp Low Beam Specification Halogen/HID/LED - Head Lamp High Beam Specification Halogen/HID/LED - High Beam Assist Current Setting ON OFF - Illumination sensor flag ON OFF - Rear defogger operation mode Normal Continuous - Security Alarm Setup ON OFF - Impact Sensor Setup ON OFF Option setting Alarm delay setup ON OFF - Lockout prevention ON OFF - Impact sensor ON OFF Option setting Buzzer sounding setting ON OFF - Abnormal warning lamp flashing setting ON OFF - Automatic lock setting ON OFF - Door open warning ON OFF - Dome Light Alarm Setting ON OFF - Auto A/C ECU Setting ON OFF - Wiper Deicer setting ON OFF - Sedan/Wagon Setting WAGON SEDAN - MT/AT Setting MT AT - Seat Memory Setting ON OFF - Illumination Sensor Setting ON OFF - Factory initial setting Factory Market Do not set to Factory mode. Sunroof setting ON OFF - Welcome Light (Exit) OFF/30 Sec/60 Sec/90 Sec - Welcome Light Off Delay Time (Approaching) OFF/30 Sec/60 Sec/90 Sec - Keyless Buzzer Volume 1 2 3 4 5 6 7 - Auto Dimmer Cancel setting 0 (OFF)/Least/Less/Normal/More/Most -
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.