Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014OUTBACK 2.5I, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (AUTOMATIC TRANSAXLE)AT MAIN CASEASSEMBLYINPUT CLUTCH PACK ASSEMBLY

2014 Subaru Outback 2.5i, Standard Trans

Input Clutch Pack Assembly

2014 Subaru Outback 2.5i, Standard TransSECTION Input Clutch Pack Assembly

WARNING: This page is about a different variant/trim than selected.

Assemble the input clutch assembly to rear internal gear.

Fig 1: Assembling Input Clutch Assembly To Rear Internal Gear
Courtesy of SUBARU OF AMERICA, INC.
Install the front carrier, and then install the snap ring.

Fig 2: Installing Front Carrier And Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Install the thrust bearing.
Install the front sun gear.

Fig 3: Installing Front Sun Gear
Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.