Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014OUTBACK 2.5I, STANDARD TRANSREPAIR AND DIAGNOSISBRAKESMECHANICAL - HYDRAULICBRAKE SYSTEMFRONT DISC BRAKE ASSEMBLYINSTALLATION

2014 Subaru Outback 2.5i, Standard Trans

Front Disc Brake Assembly: Installation

2014 Subaru Outback 2.5i, Standard TransSECTION Installation

NOTE: Before installation, remove mud and foreign matter from the caliper body and support.

Before installation, check each part. Refer to INSPECTION .
Apply a thin coat of grease to the support.
Grease:

Grease contained in the pad kit or WAKO grease V160

Fig 1: Identifying Thin Coat Of Grease Applying Area On Support
Courtesy of SUBARU OF AMERICA, INC.
Install the support to the front axle housing.
Tightening torque:

Mounting bolt: 120 N.m (12.24 kgf-m, 88.5 ft-lb)
Apply a thin coat of grease contained in the pad kit to the pad clip.

Fig 2: Identifying Thin Coat Of Grease Applying Area On Pad Kit To Pad Clip
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) or grease contained in the pad kit to both surfaces of the pad and inner shim.

Fig 3: Identifying Thin Coat Of Grease Applying Area On Pad And Inner Shim Pad Kit Surfaces
Courtesy of SUBARU OF AMERICA, INC.
Install the brake pad to the support.
CAUTION:
- Be sure to install so that the pad return spring faces the input side of the direction of brake rotor rotation, as shown in the figure.
- Correctly install the pad return spring to the supporting surface of the pad clip as shown in the figure.
- If the pad return spring is deformed or damaged, replace the brake pad.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.