Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014OUTBACK 2.5I, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEM - SECURITY AND LOCKSFUNCTION SETTING (CUSTOMIZE)PROCEDURE

2014 Subaru Outback 2.5i, Standard Trans

Function Setting (Customize): Procedure

2014 Subaru Outback 2.5i, Standard TransSECTION Procedure

Check that the vehicle status is as follows:
- Ignition switch OFF
- One window is completely open
- Keyless access system is activated (or disabled if re-activating)
Sit in the driver's seat with the door closed and press the door lock switch to UNLOCK once.
Open the driver's door within five seconds.
Within 5 seconds, with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
Within 30 seconds, perform the closing → opening operation of the driver's door twice.
Within 30 seconds, with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
Within 30 seconds, perform the closing → opening operation of the driver's door once.
Within five seconds, close the driver's door.
- The access buzzer sounds once (long sound) to indicate that the keyless access system is disabled (when the system is already disabled, the buzzer sounds once shortly to indicate that it is activated).
NOTE:
- Perform the same procedures to re-activate the keyless access system from the disabled condition.
- If the driver's door is opened or closed in step 4) or step 6), the cancel operation is disabled.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.