Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014OUTBACK 2.5I, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASSUBARU EYESIGHT SYSTEM (DRIVER ASSIST) (DIAGNOSTICS)CAMERA ADJUSTMENT, INSPECTIONPROCEDUREAUTOMATIC ADJUSTMENT AND FUNCTION CHECK BY DRIVING
2014 Subaru Outback 2.5i, Standard Trans
Automatic Adjustment And Function Check By Driving
2014 Subaru Outback 2.5i, Standard TransSECTION Automatic Adjustment And Function Check By Driving
NOTE:
- Perform the automatic adjustment and function check by driving to improve the recognition accuracy of stereo camera, when the stereo camera is replaced or re-adjusted, or the EyeSight function does not operate correctly.
- The automatic adjustment and function check by driving adjust the stereo camera more in detail, based on the stereo camera adjustment using RANDOM CHART.
- Perform this procedure after finishing stereo camera adjustment and inspection.
- On «ADA adaptive cruise control system» display, select {EyeSight (from 2009MY)}.
- On «EyeSight (from 2009MY)» display, select {Current Data Display & Save}.
- On «Current Data Display & Save» display, display the {Automatic adjustment status}. < Refer to OPERATION , Read Current Data. >
- Drive the vehicle until [Automatic adjustment status] displays {1F}.
Drive the vehicle so that the distance from the preceding vehicle is 40 m or more.
Display Remarks Unit of measure Note (at idling) Automatic adjustment status Index for automatic adjustment operation performed by the driving test after the completion of the optical axis adjustment - {1F} is displayed when completed. NOTE:- The time required until {1F} is displayed may be longer depending on the road condition etc.
- For new vehicles, {00} may be displayed. It is not necessary to drive the vehicle before delivery because high-accuracy aiming has been performed at vehicle shipment.
- On {Current Data Display & Save} display, display [Lane recognition status] to check if any of the following appears.
- Right lane is recognized: 01
- Left lane is recognized: 10
- Right and left lane are recognized: 11
Display Remarks Unit of measure Note (at idling) Lane recognition status Display of lane recognition status - Recognized when vehicle lane can be seen by 20 m or more. - On {Current Data Display & Save} display, display [Distance from leading vehicle] to check if the distance from the preceding vehicle is approximately the same.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.