Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014OUTBACK 2.5I, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASSUBARU EYESIGHT SYSTEM (DRIVER ASSIST) (DIAGNOSTICS)BASIC DIAGNOSTIC PROCEDUREPROCEDURE
2014 Subaru Outback 2.5i, Standard Trans
Basic Diagnostic Procedure: Procedure
2014 Subaru Outback 2.5i, Standard TransSECTION Procedure
CAUTION:
- Start the diagnosis after the engine has started. (Cruise control main switch does not turn on even if it is pressed before the engine starts.)
- When performing diagnosis, observe the legal speed limit on the road.
- The cancel code will also appear when the cruise control is cancelled by the driver's operation. Do not confuse them.
- Be sure to get an assistant to support the diagnosis while driving, and have him/her operate the select monitor.
- Before clearing the memory, be sure to record the following data. (Obtain the data before inspection because the previous trouble or temporary stop history will be cleared once the memory clear is performed.)
- All Diagnostic Trouble Codes (DTCs)
- Cancel code of stereo camera
- Current data of stereo camera (To obtain the data concerning camera adjustment information, previous trouble or temporary stop history, all data must be measured for a few seconds after the engine has started.)
| Step | Check | Yes | No |
|---|---|---|---|
| 1 PREPARATION BEFORE INSPECTION. Using the Check List for Interview, confirm the condition of the malfunction occurrence from the user. < Refer to CHECK , Check List for Interview. > |
Is there any component that obviously seems to affect the malfunction? | Repair or replace the component that seems to affect the malfunction. | Go to step 2 . |
| 2 CHECK DTC. Read the DTC using Subaru Select Monitor.
NOTE:
When communication with the stereo camera could not be established, check the circuit. < Refer to
COMMUNICATION FOR INITIALIZING IMPOSSIBLE , INSPECTION, Subaru Select Monitor. >
|
Is DTC displayed on Subaru Select Monitor? | Perform the diagnosis according to the List of Diagnostic Trouble Code (DTC). < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > If the diagnostic codes other than the stereo camera are displayed, refer to the diagnosis for the relevant codes. | Go to step 3 . |
| 3 CHECK CANCEL CODE. Read the cancel code related to the stereo camera using the Subaru Select Monitor. |
Is cancel code related to the stereo camera displayed on the Subaru Select Monitor? | Perform the diagnosis according to the List of Cancel Code. < Refer to LIST OF CANCEL CODE . > | Go to step 4 . |
| 4 PERFORM DIAGNOSTICS WITH PHENOMENON. Using the diagnostics with phenomenon, perform inspection. < Refer to DIAGNOSTICS WITH PHENOMENON . > |
Does the following apply? No phenomenon described in the diagnostics with phenomenon occur/No indicators show sign of malfunction. | Finish the diagnosis. | Perform the diagnosis according to the diagnostics with phenomenon. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.