Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014OUTBACK 2.5I, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESVEHICLE DYNAMICS CONTROL SYSTEMFRONT ABS WHEEL SPEED SENSORREMOVAL

2014 Subaru Outback 2.5i, Standard Trans

Front ABS Wheel Speed Sensor: Removal

2014 Subaru Outback 2.5i, Standard TransSECTION Removal

Disconnect the ground cable from battery.
Lift up the vehicle, and then remove the front wheels.
Remove the front ABS wheel speed sensor.
CAUTION:
- Be careful not to damage the sensor.
- Do not apply excessive force to the sensor harness.
1. Disconnect the front ABS wheel speed sensor connector in the engine compartment.
  
  Fig 1: Locating Front ABS Wheel Speed Sensor Connector
  Courtesy of SUBARU OF AMERICA, INC.
2. Remove each harness clip and grommet.
3. Remove the bolts, and remove the front ABS wheel speed sensor from the front axle housing.
  
  Fig 2: Locating Front ABS Wheel Speed Sensor Mounting Bolt
  Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.