SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014OUTBACK 2.5I, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR/INTERIOR TRIMEXTERIOR TRIM & INTERIOR TRIMFRONT GRILLEREMOVAL
2014 Subaru Outback 2.5i, Standard Trans

Front Grille: Removal

2014 Subaru Outback 2.5i, Standard TransSECTION Removal
  1. Remove the front bumper face assembly.
    1. Remove the clips and turn over the front end of front mud guard. (Model with fog light)
      Fig 1: Locating Front End Of Front Mud Guard Clips
      G06653452Courtesy of SUBARU OF AMERICA, INC.
    2. Disconnect the front fog light connector. (Model with fog light)
      Fig 2: Disconnecting Front Fog Light Connector
      G08585118Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the clips at the upper side of the bumper.
    4. Remove the clips from the fender.
    5. Remove the clips at the lower side of bumper.
      Fig 3: Locating Lower Side Of Bumper Clips
      G08584097Courtesy of SUBARU OF AMERICA, INC.
    6. Detach the flange section on the bumper face side from the bracket side front UPR.
      CAUTION: Do not pull forcibly. It may damage the flange sections of the bumper face.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.