Check Microphone Connection

2014 Subaru Outback 2.5i, Standard TransSECTION Check Microphone Connection

Perform the inspection mode of the microphone connection.

  1. When "HOOK OFF" button of the satellite switch is pressed with telephone unregistered, the screen switches to Β«BTΒ» and "Welcome" is displayed.
    Fig 1: Display - BT And Welcome Screen
    G08584557Courtesy of SUBARU OF AMERICA, INC.
  2. While "Welcome" is displayed, press "+" β†’ "HOOK OFF" β†’ "+" β†’ "HOOK OFF" β†’ "+" continuously in 5 seconds.
  3. After "Speak loudly" is displayed, the inspection mode of the microphone connection is started.
    Fig 2: Display - Speak Loudly Screen
    G08584558Courtesy of SUBARU OF AMERICA, INC.
  4. When the inspection mode of the microphone connection is completed, the inspection result is displayed.

    MIC: good: normal

    MIC: CHECK: There is something wrong with the connection status of the microphone. Check the following items.

    • Connection status of the microphone
    • Change the microphone or audio unit and check the microphone connection again then replace the faulty part.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.