Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 13 (EXHAUST SYSTEM (H6DO))MUFFLERREMOVAL
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Section 13 (Exhaust System (H6DO)): Muffler: Removal
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
- Lift up the vehicle.
- Remove the muffler from rear exhaust pipe.
- Apply a coat of spray type lubricant to the mating area of cushion rubber.
- Remove the muffler from the cushion rubber.CAUTION: Be careful not to drop the muffler during removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.