SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 54 (SECURITY AND LOCKS)SECURITY SYSTEMINSPECTIONCHECK SECURITY SYSTEM CONDITION MEMORY
2014 Subaru Legacy 2.5i, Automatic CVT Trans

Check Security System Condition Memory

2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Check Security System Condition Memory
WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull out the key from the ignition switch, or turn the ignition to OFF.
  2. Close all the doors and rear gate.
  3. Open the front hood.
  4. Press the LOCK button of the keyless transmitter.
    NOTE: Wait until the security indicator light blinks twice within 0.5 seconds at 2 second intervals.
    If the 30 second monitoring lag has been set, wait for 30 seconds.
  5. Disconnect the ground cable from battery.
  6. Connect the battery ground terminal.
  7. Check that the security indicator light blinks twice within 0.5 seconds at 2 second intervals. When it does not blink, replace the body integrated unit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.