Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 54 (SECURITY AND LOCKS)IMPACT SENSOROPERATIONIMPACT SENSOR SETTING USING SUBARU SELECT MONITOR
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Impact Sensor Setting Using SUBARU Select Monitor
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Impact Sensor Setting Using SUBARU Select Monitor
WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Prepare the Subaru Select Monitor kit.
- Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
- On «System Selection Menu» display, select {Integ. unit mode}.
- Select {Unit customizing} from {Work Support}.
- Make a impact monitor setting.
- When installing: ON
- When removing: OFF
- Make a impact monitor ON/OFF setting.
- When installing: ON
- When removing: OFF
- Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.