Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENTATION SYSTEM & DRIVER INFORMATION CENTERCOMBINATION METER SYSTEMOPERATIONDEMONSTRATION MODE (LUMINESCENT METER MODEL)
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Demonstration Mode (Luminescent Meter Model)
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Demonstration Mode (Luminescent Meter Model)
The demonstration mode screen of the combination meter can be displayed according to the following procedure.
CAUTION:
- While IG and ACC is off and the odo/trip meter is not displayed, perform the steps described in 1 through 6 within 10 seconds.
- To avoid battery discharge, perform the operation under the following condition.
- Perform the operation while the battery is being charged.
- While performing the operation and displaying the demonstration mode, close all doors and do not operate any electrical parts.
- If the battery voltage is low, the demonstration mode is not initiated.
- If the "Demo. Mode Setting Screen" is not turned to on in the dealer customize mode, the demonstration mode is not initiated.
- When the demonstration mode display is completed, make sure that the "Demo. Mode Setting Screen" is turned to off in the dealer customize mode. Do not deliver the vehicle to the customer with the "Demo. Mode Setting Screen" is on.
- Even if the backup fuse is removed, the demonstration mode can be initiated.
- Press the trip meter knob twice.NOTE: When the trip meter knob is pressed once, the odo/trip meter is displayed.
- Press the information switch five times within three seconds after the above operation 1) is performed.
- Press the trip meter knob once.
- Press the information switch five times.
- Press the trip meter knob once.
- Press the information switch five times.
- The "demonstration mode" is initiated.
Each demonstration mode screen is displayed in the TFT.
CAUTION:
If the procedure is not performed properly, stop the operation and wait until the odo/trip meter display disappears (for approx. 10 seconds), and then perform the procedure from 1) to 6) again after confirming that the display disappeared.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.