Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMEXTERIOR TRIM & INTERIOR TRIMINSTRUMENT PANEL LOWER COVERREMOVAL
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Instrument Panel Lower Cover: Removal
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Removal
- Disconnect the ground cable from battery.
- Remove the clips, and remove the instrument panel side cover LH.
- Remove the instrument panel lower cover.
- Remove the clips and data link connector, and remove the instrument panel lower cover under.
- Remove the screws and clips and release the claws, and remove the instrument panel lower cover while disconnecting the harness connectors.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.