Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMSTOP LIGHT SYSTEMINSPECTIONCHECK STOP LIGHT SWITCH
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Check Stop Light Switch
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Check Stop Light Switch
- Disconnect the stop light switch connector.
- Measure the resistance between stop light switch terminals.
Preparation tool:Β
Circuit testerΒ
Terminal No. Inspection conditions Standard 2 - 3 When brake pedal is depressed Less than 1 Ξ© When brake pedal is released 1 MΞ© or more - Replace the stop light switch if the inspection result is not within the standard value.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.