Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMSPOT MAP LIGHTREMOVAL
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Spot Map Light: Removal
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Removal
NOTE:
The spot map light is a single unit with the overhead console or stereo camera cover.
- Disconnect the ground cable from battery.
- Remove the overhead console assembly. (Models without EyeSight)
- Push and open the rear end of the overhead console lid, and remove the screws.
- Remove the clips and pull out the overhead console to disconnect the connectors.
- Remove the stereo camera cover assembly. (Models with EyeSight) Refer to REMOVAL .
- Release the claws, then detach the spot map light cover and bulb.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.