Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMSPOT MAP LIGHTINSPECTIONSPOT MAP LIGHT SWITCH
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Spot Map Light Switch
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Spot Map Light Switch
- Remove the overhead console assembly.
- Measure the resistance between spot map light switch terminals.
Preparation tool:
Circuit tester
- Models without EyeSight
Terminal No. Inspection conditions Standard Connection diagram - Switch OFF 1 MΩ or more - 6 - 5 Switch ON Less than 1 Ω 6 - 7 Switch door Less than 1 Ω - Models with EyeSight
Terminal No. Inspection conditions Standard Connection diagram - Switch OFF 1 MΩ or more - 13 - 12 Switch ON Less than 1 Ω 13 - 14 Switch door Less than 1 Ω
- Models without EyeSight
- Replace the overhead console assembly or stereo camera cover assembly if the inspection result is not within the standard value.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.