Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMREAR FINISHER LIGHT ASSEMBLYREMOVALOUTBACK MODEL

2014 Subaru Legacy 2.5i, Automatic CVT Trans

Outback Model

2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Outback Model

Disconnect the ground cable from battery.
Remove the rear gate trim. Refer to REMOVAL .
Remove the rear gate garnish. Refer to REMOVAL .
Release the clips and claws, then detach the rear finisher light side cover.

Fig 1: Identifying Rear Finisher Light Side Cover
Courtesy of SUBARU OF AMERICA, INC.
Remove the rear finisher light assembly.
1. Disconnect the connector.
2. Remove the nuts and release the pin, then remove the rear finisher light assembly.
  
  Fig 2: Locating Rear Finisher Light Assembly Mounting Nuts
  Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.