Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMREAR COMBINATION LIGHT ASSEMBLYINSTALLATION
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Rear Combination Light Assembly: Installation
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Installation
CAUTION:
For sedan models, replace the seal gasket of the rear combination light assembly with a new part. If the seal gasket is reused, water may come inside of the vehicle.
Install each part in the reverse order of removal.
Tightening torque:
Sedan model: 4.5 N.m (0.46 kgf-m, 3.3 ft-lb)
OUTBACK model: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.