Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMLIGHT CONTROL SENSORREMOVAL

2014 Subaru Legacy 2.5i, Automatic CVT Trans

Light Control Sensor: Removal

2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Removal

NOTE: The light control sensor is integrated with the sunload sensor.

Disconnect the ground cable from battery.
Remove the light control sensor.
CAUTION: Be careful not to damage the sensors and interior trims when removing.
1. Release the claws and clips, then detach the side speaker cover (RH).
  
  Fig 1: Identifying Side Speaker Cover (RH)
  Courtesy of SUBARU OF AMERICA, INC.
2. Push out the light control sensor by pressing the left and right claws.
3. Disconnect the connector, and remove the light control sensor.
  
  Fig 2: Removing Light Control Sensor
  Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.