Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMFRONT FOG LIGHT BULBREMOVALOUTBACK MODEL

2014 Subaru Legacy 2.5i, Automatic CVT Trans

Outback Model

2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Outback Model

Disconnect the ground cable from battery.
Remove the clips and turn over the front end of front mud guard.

Fig 1: Locating Front Mud Guard Mounting Clips
Courtesy of SUBARU OF AMERICA, INC.
From the bottom of bumper face, remove the front fog light bulb.
1. Disconnect the connector.
2. Remove the bulb.
  
  Fig 2: Removing Front Fog Light Bulb
  Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.