Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALACCESSORY DRIVE BELTSENGINE MECHANICAL (H4DO)CYLINDER HEADDISASSEMBLY
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Cylinder Head: Disassembly
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Disassembly
- Remove the chain cover securing bolt from the cylinder head LH.
- Remove the stud bolts from the cylinder head.
- Remove the valve collet, valve, valve spring retainer, valve spring and valve spring seat from the cylinder head RH.CAUTION: During work, place a waste cloth, etc. to avoid scratching the mating surface of the cylinder head RH.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.