Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESWHEEL HUBSAXLE SHAFTS, PROPELLER SHAFT & HUBSREAR HUB UNIT BEARINGASSEMBLY
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Rear Hub Unit Bearing: Assembly
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Assembly
- Install the hub unit bearing to the ST securely.
PREPARATION TOOL:
ST: HUB STAND (927080000)
- Using a press, press the new hub bolts (b) until their seating surfaces contact the hub unit bearing (a).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.